Remote check sheet
Garage Door Opener Not Working with Remote
When the wall control works, the opener motor is usually fine; focus on transmitter, receiver, and lock settings.
Do not loosen, wind, unwind, or adjust torsion springs, extension springs, lift cables, drums, or bottom brackets. Use these checks for opener controls, sensors, remotes, lights, and simple observations.
Diagrams and printables
Sensor alignment diagram
Learn button location
Error-code flowMost likely causes
| Likely cause | First safe check | Stop point |
|---|---|---|
| Remote battery | Check this before replacing parts or changing force settings. | Stop if the door is heavy, crooked, or the spring/cable system is involved. |
| Lock mode | Check this before replacing parts or changing force settings. | Stop if the door is heavy, crooked, or the spring/cable system is involved. |
| Receiver memory | Check this before replacing parts or changing force settings. | Stop if the door is heavy, crooked, or the spring/cable system is involved. |
| Antenna position | Check this before replacing parts or changing force settings. | Stop if the door is heavy, crooked, or the spring/cable system is involved. |
Step-by-step checks
Test wall control
Result: continue only if the door and opener respond normally.
Replace battery
Result: continue only if the door and opener respond normally.
Check lock button
Result: continue only if the door and opener respond normally.
Reprogram remote
Result: continue only if the door and opener respond normally.
Straighten opener antenna wire
Result: continue only if the door and opener respond normally.
On the bench
Fresh remote battery, flashlight, soft cloth, step ladder, phone camera for blink patterns.
Stop and call
The door is heavy by hand, crooked, off track, has broken spring parts, or the opener strains without moving the door.
Reset note
Unplug the opener for 30 seconds only after noting lights or codes. Do not erase remote memory unless pairing is the actual problem.
Common questions
Should I bypass the safety sensors?
No. Sensors are a required safety system. Fix alignment, wiring, or obstruction instead.
Can I increase force to make the opener close?
Only after the door moves freely by hand and the sensor path is clear. Force changes should not hide a binding door.
Why does the wall button work but the remote does not?
That usually points to lock mode, remote battery, signal range, or lost programming rather than a failed motor.